Table of Contents
Advertisement
Completing the installation
o If you are setting the appliance to recirculation mode, then you
should now fit the two carbon filters. See the "Fitting the carbon
filters" section on page 13.
o The electrical connection must correspond to the electrical
requirement noted on the rating plate, which is placed inside the
cooker hood. The appliance should now be connected to the
electrical supply. See page 14 - 15 for detailed information on
the electrical connection.
o Use a stainless steel cleaner and polish on the stainless steel
sections of the appliance.
o Refit the grease filters and then switch on the mains
Extraction mode or recirculation mode?
What is the difference between extraction and recirculation
modes?
o To get optimum performance from your cooker hood, the air will
be taken out of the room via external ducting.
o Unfortunately if you live in a flat or the hood is too far from an
outside wall, this may not be possible. The only alternative is to
recirculate the air.
In recirculation mode stale air is taken via the grease filter, and
o
passed through a charcoal filter for purification. The air then re-
enters the kitchen via an opening in the hood
What is a charcoal filter and do I need one?
o All cooker hoods have grease filters but if you are using your
cooker hood in recirculation mode, then charcoal filters must be
fitted in addition to the grease filters.
o IMPORTANT: If you are using the appliance in recirculation
mode, then PLEASE NOTE that some of the vent in the upper
chimney section must be exposed. You will have to take this into
account when calculating the minimum height of the cooker hood
when installed.
supply to the appliance. Check that the appliance is
operating correctly by selecting each speed and
switching the light bulbs on and off.
.
22
Advertisement
Table of Contents
