Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Baumatic BE605BGL
Summary of Contents for Baumatic BE605BGL
- Page 1 BE605BGL Cooker Hood...
- Page 2 User Manual for your Baumatic BE605BGL 90 cm Cooker hood NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference; for you or any person not familiar with the operation of the appliance.
-
Page 3: Table Of Contents
IMPORTANT SAFETY INFORMATION 5 – 7 Specifications of your cooker hood 8 – 9 Using your Baumatic cooker hood 9 – 12 Setting the time of day Switching the cooker hood on and setting the fan speed Using the light... -
Page 4: Environmental Note
ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person. -
Page 5: Important Safety Information
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line. - Page 6 o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN BEHIND THE GREASE FILTERS! o If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
- Page 7 o Remember that when in extraction mode, your cooker hood is removing air from your room. Ensure that proper ventilation measures are being observed. o Note: Your cooker hood is designed to remove cooking odours from the room and not steam. o Warning - Always ensure that the cooker hood been...
-
Page 8: Specifications Of Your Cooker Hood
Specifications of your cooker hood PRODUCT DIMENSIONS Height: 890 mm * Width: 600 mm (with glass panel) Depth: 420 mm DIMENSIONS OF CHIMNEY SECTION: Width: 450 mm Depth: 420 mm Your cooker hood is fitted with: o LCD touch control panel o LCD display o 3 Speeds o 1 x Aluminium grease filters... -
Page 9: Using Your Baumatic Cooker Hood
Using your cooker hood o Make sure that it has been installed by a suitably qualified person, information contained Baumatic’s installation instructions. o Find the control panel, which is located in the middle of the canopy. -
Page 10: Setting The Time Of Day
o There are several buttons on the control panel, which perform separate functions. IMPORTANT: IDEALLY YOU SHOULD TURN ON YOUR HOOD TEN MINUTES BEFORE YOU START TO COOK. OR AT THE VERY LEAST WHEN YOU BEGIN COOKING. YOU SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER YOU HAVE FINISHED COOKING. -
Page 11: Switching The Cooker Hood On And Setting The Fan Speed
Switching the cooker hood on and setting the fan speed o Press the ON/OFF button to switch the cooker hood on. o Use the speed selection button to regulate the speed that the motor is running at. The motor will run at the following speeds:- One push Low speed Two pushes... -
Page 12: Cleaning Your Baumatic Cooker Hood
YOUR HOOD TEN MINUTES BEFORE YOU START TO COOK, OR AT THE VERY LEAST WHEN YOU BEGIN COOKING. YOU SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER YOU HAVE FINISHED COOKING. Cleaning your Baumatic cooker hood IMPORTANT: BEFORE CLEANING,... -
Page 13: The Grease Filters
The grease filter o Your cooker hood includes a grease filter which helps to absorb grease particles to protect your kitchen and furniture from greasy residues. o This aluminium filter may become inflammable if it becomes saturated with this greasy residue. o To prevent this fire hazard, the filter should be cleaned regularly. - Page 14 o Soak the grease filters in hot water and washing up liquid for at least 3 minutes. Then use a soft brush to loosen any grease deposits that have formed. o Rinse the grease filters off thoroughly with hot water. o Repeat the process if required.
-
Page 15: Changing A Light Bulb
Changing a light bulb IMPORTANT: BEFORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY. o Prior to touching the light bulbs ensure that they have cooled down. o Find the bulb that requires replacement, you will find it located in the light fixture which is inside the exposed section of the canopy. -
Page 16: Fitting The Carbon Filter
o If the lights still do not work, make sure that the bulbs are fitted properly into their housings before you call for technical assistance. Fitting the carbon filters If the appliance is to be used in recirculation mode then it is necessary to fit carbon filters. -
Page 17: Installation
Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated on the rating plate are exactly the same as the voltage and frequency in your home. The rating plate can be found behind the grease filters. -
Page 18: Before Beginning Installation
Blue = Neutral, Brown = Live, Green/Yellow = Ground If you only find two wires in the main’s lead (blue and brown), then neither must be connected to the earth terminal. o As the colours of the wires in the appliance’s mains lead may not correspond with the coloured markings identifying the terminals in your spur box, please proceed as follows: o The blue wire must be connected to the... -
Page 19: Extraction Mode Or Recirculation Mode
o In addition check whether there is an electrical socket available, which will be accessible after the hood is mounted. If you are going to use the appliance in extractor mode, you should also ensure that there is space to connect a fumes discharge device to the outside. -
Page 20: Installing Your Cooker Hood
Please note that the styles of cooker hood shown in the line drawings in the following pages are sometimes different to the shape of the BE605BGL. However the installation method shown is correct and MUST be followed. IMPORTANT: YOUR COOKER HOOD SHOULD BE CONNECTED TO YOUR MAINS SUPPLY AFTER THE REST OF THE INSTALLATION PROCESS HAS BEEN COMPLETED. - Page 21 PLEASE NOTE: The cooker hood should be placed at a minimum distance of 70 cm from the cooking surface below. 3) Drill the screw holes in the wall on the positions that you have marked in step 2. Insert rawl plugs into all of the holes that you have drilled and then fasten the support screws halfway in, leaving them 10 mm out of the wall.
-
Page 22: Connecting To External Ducting
5) Screw the anchoring screws through the relevant holes in the cooker hood. Fully tighten the anchoring screws into the wall. Connecting to external ducting o Connect the coupling to the top of the cooker hood, and then connect a 125 mm ducting hose to the coupling (please note that the ducting hose is not supplied with the appliance). -
Page 23: Completing The Installation
Completing the installation o If you are setting the appliance to recirculation mode, then you should now fit the two carbon filters. See the “Fitting the carbon filters” section on page 16. o The electrical connection must correspond to the electrical requirement noted on the rating plate, which is placed inside the cooker hood. -
Page 24: Troubleshooting
Troubleshooting IMPORTANT: If your cooker hood appears not to be operating properly, before contacting Baumatic Customer Care Department, please refer to the checklist below. My cooker hood will not start. o Check that the hood is connected to the electricity supply o Check that the fan speed control is set correctly. - Page 25 Or any installation other than the one specified by Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.
-
Page 26: Contact Details
Czech Republic United Kingdom Baumatic CR spol s.r.o. Baumatic Ltd., Průmyslová zóna Sever 696 Baumatic Buildings, 460 11 Liberec 11 6 Bennet Road, Czech Republic Reading, Berkshire RG2 0QX +420 483 577 200 United Kingdom www.baumatic.cz Sales Telephone (0118) 933 6900...