Table of Contents
Advertisement
Sub base
Optional accessory
NOTE: The sub base can be installed on either side
of the tool.
1.
Insert the rods into the holes on the side of the
tool. At this time, insert the rod from the end with the
groove.
► 1. Rod 2. Groove
2.
Secure the sub base with the hex socket bolts.
Tighten the hex socket bolt while holding the flat surface
on the rod with the wrench.
5
► 1. Hex socket bolt 2. Sub base 3. Flat surface
4. Rod 5. Wrench 6. Hex wrench
NOTE: To tighten the hex socket bolts, use the
wrench and hex wrench supplied with the sub base
set.
1
2
4
3
2
1
6
23 ENGLISH
3.
Make sure that the groove on the rod cannot be
seen and then secure the rod using the clamping screw
supplied with the sub base set as illustrated.
1
► 1. Clamping screw 2. Groove
4.
Attach two fence shafts onto the holes on the sub
base using the hex wrench supplied with the tool.
The layout of the fence shaft varies depending on the
purpose of cutting.
► 1. Hex wrench 2. Fence shaft
When using as a extension fence
2
1
2
2
Advertisement
Table of Contents
