GRP Port Connection Guidelines
GRP Auxiliary and Console Port Connections
Figure 2-12 GRP Auxiliary and Console Port Connections
Modem
Console terminal
Note
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
2-26
The GRP has two EIA/TIA-232 ports
Auxiliary port— DB-25 plug, DTE-mode port for connecting a modem or
•
other DCE device (such as a CSU/DSU or another router) to the GRP.
•
Console port—DB-25 receptacle, DCE-mode port for connecting a data
terminal to perform the initial configuration of the router.
The auxiliary and console ports are asynchronous serial ports. Devices
Note
connected to these ports must be capable of asynchronous transmission.
Because the connectors on some standard cables are large enough to interfere with
the front covers installed on the card cages, a lower-profile cable adapter is
included that permits you to connect a flat cable with modular RJ-45 plugs to the
GRP console port.
EIA/TIA-232 cables are not available from Cisco, but are available from any
commercial cable vendor.
(Figure
2-12):
DB-25 female
DB-25 male
GRP
Chapter 2
Preparing for Installation
Auxiliary
port
Console
port
OL-11495-01