Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Toolless Blade Holder Section (Model JR100D) (cont.)
ASSEMBLING
(2) Do further step for Assembling in the order of Fig. 14, 15, 16, 17, 18.
Fig. 14
3. Mount Guide sleeve to Blade guide.
And align the holes each other for easy
assembling of Shoulder pin 5 and Pin 3
in the next step.
Fig. 15
Slotted
screwdriver
Shoulder
pin 5
Compression spring 2
Fig. 16
Inner projection
Note; Locate this gray portion to
Note; These concaves on
Connecting sleeve fit to the inner
projection of Driving sleeve.
4. Insert Compression spring 6 and Shoulder pin 5 into the large hole
5. Press down Push pin with Slotted screwdriver
till it stops while pushing Shoulder pin 5.
Slotted
screwdriver
Guide
sleeve
Pin 3
Driving sleeve
Shoulder pin 5 and mount
Driving sleeve to Guide sleeve.
of Guide sleeve.
Insert Pin 3 into the small hole of another side of Guide sleeve.
Shoulder
pin 5
Connecting
sleeve
Push pin
Blade guide
7. While pressing Shoulder pin 5,
assemble Driving sleeve.
6. And then, remove Slotted
Screwdriver.
So, Push pin is pushed back
by Compression spring 2 and
fits to Shoulder pin 5.
P 8/ 12
Advertisement
