Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Toolless Blade Holder Section (Model JR100D)
DISASSEMBLING
(1) Disassemble Housing (R) from Housing (L) and remove Gear housing section from Housing (L) (Fig. 2, 3).
(2) Remove Shoe from Gear section by unscrewing M4x10 Countersunk head screws (Fig. 3).
(3) Disassemble Toolless blade holder section (Fig. 12).
Fig. 12
1. Remove Protector and
Retaining ring 16 by
levering it up with
Slotted screwdriver.
Retaining ring 16
Protector
ASSEMBLING
(1) Assemble Blade guide to Slider (Fig. 9) in case Blade guide is removed from Slider.
(2) Mount Torsion spring 17 and Connecting sleeve to Blade guide. And then, inert Compression spring 2 and
push pin (Fig. 13).
Fig. 13
1. Assemble Torsion spring 17 to Blade guide by inserting its
long tail into the slit of Blade guide. And insert the short tail
of the Torsion spring into the hole of Connecting sleeve.
Connecting sleeve
short tail
Torsion spring 17
long tail
Blade guide
2. Remove Driving sleeve slowly,
while paying attention that Shoulder
pin is not slung by Compression
spring 6.
Remove Pin 3, Shoulder pin 5 and
Compression spring 6 from Guide
sleeve.
Driving
Pin 3
sleeve
Compression
spring 6
Shoulder pin 5
Connecting sleeve
3. Remove Guide sleeve, Connecting
sleeve, Push pin, Compression
spring 2 and Torsion spring 17 from
Blade guide.
Torsion spring 17
Compression spring 2
2. Insert Compression spring 2 and Push pin
into the slit of Blade guide.
Blade guide
P 7/ 12
Connecting sleeve
Push pin
Guide sleeve
Push pin
Compression spring 2
Advertisement
