Adding Or Replacing An Ac Power Supply - Cisco 10005 Installation Manual

Adding or Replacing an AC Power Supply

Installing a Second AC Power Supply
Warning
Step 1
Step 2
Step 3
Step 4
78-12652-01
This section describes how to add or replace an AC power supply in a Cisco 10005
chassis. It contains these procedures:
Installing a Second AC Power Supply
•
Replacing an AC Power Supply
•
Troubleshooting the Installation
•
Never install an AC power module and a DC power module in the same
chassis.
Follow these steps to install a second AC power supply for redundancy:
Put on an antistatic wrist or ankle strap. Attach the strap to the ESD grounding
jack on the front of the chassis or to a bare metal surface of the chassis.
At the rear of the chassis, loosen the captive screws to remove the blank cover
from the empty power compartment.
Before you install the new power supply, push on the left side of the power switch
to set the power supply to standby mode.
Insert the new AC power supply all the way into the power bay to ensure a secure
connection to the midplane
Adding or Replacing an AC Power Supply
(Figure 2). Tighten the captive screws.
Cisco 10005 ESR AC Power Supply Installation
7