Removing The Power Supply - Cisco 3600 Series Configuration Note

Removing the Power Supply

Removing the Power Supply
After you remove the cover from the chassis, follow this procedure to remove the power supply:
Step 1
Figure 8
10 Cisco 3600 Series Power Supply Configuration Note
Find the power cable harness located on the rear of the power supply (toward the front of
the router). (See Figure 8 and Figure 9.)
Cisco 3620 Power Supply Wiring Harness
Two, two-pin Cable tie-wraps
connectors
to the fans
Six-pin connector
to the motherboard
Power supply