Specifications - Makita TW0350 Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Socket
2-2. Anvil

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Max. fastening torque
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for fastening bolts and nuts.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test method
and may be used for comparing one tool with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
3-1. Socket
3-2. O-ring
3-3. Pin
Model
Standard bolt
High tensile bolt
Square drive
-1
)
Overall length
Net weight
Safety class
noise level determined
) : 93 dB (A)
pA
) : 104 dB (A)
WA
value (tri-axial vector
2
) : 11.5 m/s
h
2
ENE036-1
WARNING:
The vibration emission during actual use of the power
•
ENF002-2
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENG905-1
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Impact Wrench
Model No./ Type: TW0350
Conforms to the following European Directives:
ENG900-1
2006/42/EC
sum)
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
ENG901-1
3
4-1. Limit mark
5-1. Brush holder cap
5-2. Screwdriver
TW0350
M12 - M22
M12 - M16
12.7 mm
2,000
2,000
350 N·m
283 mm
3.0 kg
/II
ENH101-17