Safety Guidelines; General Precautions - Cisco Wide Area Application Engine 612 Hardware Installation Manual

Safety Guidelines

Warning
Warning
Warning
Safety Guidelines

General Precautions

Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
2-4
This product requires short-circuit (overcurrent) protection, to be provided as
part of the building installation. Install only in accordance with national and
local wiring regulations. Statement 1045
Installation of the equipment must comply with local and national electrical
codes. Statement 1074
Hazardous voltage or energy may be present on DC power terminals. Always
replace cover when terminals are not in service. Be sure uninsulated
conductors are not accessible when cover is in place. Statement 1075
To reduce the risk of bodily injury, electrical shock, fire, and damage to the
equipment, observe the precautions in this section.
Observe the following general precautions for using and working with your
system:
Observe and follow service markings. Do not service any Cisco product
•
except as explained in your system documentation. Opening or removing
covers that are marked with the triangular symbol with a lightning bolt may
expose you to electrical shock. Components inside these compartments
should be serviced only by an authorized service technician.
If any of the following conditions occur, unplug the product from the
•
electrical outlet and replace the part or contact your authorized service
provider:
The power cable or plug is damaged.
–
– An object has fallen into the product.
The product has been exposed to water.
–
Chapter 2 Preparing to Install the Cisco Wide Area Application Engine
OL-9137-02