Perform Initial Configuration - Cisco AS5400XM Quick Start Manual

Last reset from IOS reload
Manufacture Cookie Info:
EEPROM Version 0x4, Board ID 0x4BD,
Board Hardware Version 1.11, Item Number 800-6572289-01,
Board Revision 02, Serial Number JAB082904P4.
Processor 0x0, MAC Address badb.adba.d044
2 Gigabit Ethernet interfaces
6 Serial interfaces
648 terminal lines
1 Channelized T3 port
512K bytes of NVRAM.
125184K bytes of ATA External CompactFlash (Read/Write)
Press RETURN to get started!
If the
Note
rommon 1>
monitor, see the universal gateway ROM monitor information in the Cisco IOS Configuration Fundamentals
Configuration Guide for your Cisco IOS software release.
7

Perform Initial Configuration

The information in this document applies to the Cisco AS5350XM and Cisco AS5400XM universal gateways.
Note
At this point you can continue, using the setup command facility, or you can configure the universal gateway manually using
the command-line interface (CLI).
• The following section describes the procedure for the setup command facility for the initial configuration.
• See the "Initial Configuration Using the CLI (Manual Configuration)" section on page 36 for information about manual
configuration using the CLI.
Initial Configuration Using the Setup Command Facility
This section shows how to prepare the system to perform basic communication functions through its Ethernet and WAN
interfaces.
The messages displayed depend on the Cisco IOS software release and cards installed in your system. The screen
Note
displays in this section are for reference only and might not exactly match the messages on your console.
Note If you make a mistake while using the setup command facility, you can exit and run the facility again. Press Ctrl-C, and
type setup at the enable mode prompt (
To proceed using the setup command facility, enter yes:
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
prompt appears, your system has booted in ROM monitor mode. For information on the ROM
Router#
).
33