How To Perform The Initial Gateway Configuration - Cisco 3545 PRI Installation And Upgrade Manual

How to Perform the Initial Gateway Configuration

Figure 2-6
Wait for the blue SWAP RDY LED to light up. The SWAP RDY LED indicates that it is safe to remove
Step 3
the module.
Note
Remove the module completely.
Step 4
Insert a blank cover panel provided by Cisco.
Step 5
Secure the blank cover panel screws.
Step 6
Caution
How to Perform the Initial Gateway Configuration
•
•
•
•
•
•
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Releases 5.6 and 5.7
2-10
Removing a Module from the Cisco Unified Videoconferencing 3545 Chassis
It may take up to one minute for the LED to light up while the Windows operating system is
shutting down.
The light goes out when the board is completely detached from the backplane.
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference
(EMI) that might disrupt other equipment; and they direct the flow of cooling air through the
chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers
are in place.
About the Initial Configuration and Boot Phases, page 2-11
Connecting to a PC, page 2-11
Setting the IP Address, page 2-11
Setting Ethernet Speed and Duplex Parameters, page 2-13
Changing the Configuration Tool Login Password, page 2-14
Upgrading Gateway Software, page 2-14
Chapter 2 Installing the Cisco Unified Videoconferencing 3545 Gateway
OL-17011-01