3
Install Chassis
The information in this document applies to the Cisco AS5350XM and Cisco AS5400XM universal gateways.
Note
Safety Information
For safety information you need to know before working on your Cisco universal gateway, see the Regulatory Compliance and
Safety Information document that accompanied this device.
Setting Up the Chassis
You can install the chassis in a rack or set it on a desktop. Select the procedure that best meets the needs of your network:
• Rack-Mounting the Chassis, page 5
• Desktop Installation, page 7
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Rack-Mounting the Chassis
This section describes how to rack-mount the chassis. The universal gateway arrives with 19-inch (48.26-cm) rack-mount
brackets and larger brackets for use with a 23-inch (58.42-cm) or 24-inch (60.96-cm) rack.
Figure 1
Cisco AS5350XM Universal Gateway Rack-Mount Brackets
Bracket for 19-inch rack
Figure 2
Cisco AS5400XM Universal Gateway Rack-Mount Brackets
Bracket for 19-inch rack
The following information will help you plan your equipment rack configuration:
• Enclosed racks must have adequate ventilation. Ensure that the rack is not congested, because each unit generates heat. An
enclosed rack should have louvered sides and a fan to provide cooling air. Heat generated by equipment near the bottom of
the rack can be drawn upward into the intake ports of the equipment above.
Bracket for 23-inch rack
Bracket for 23- or 24-inch rack
5