Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita DHP486RTE
Summary of Contents for Makita DHP486RTE
- Page 1 INSTRUCTION MANUAL Cordless Hammer Driver Drill DHP486 Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model: DHP486 Drilling capacities Masonry 16 mm Steel 13 mm Wood Auger bit: 50 mm Self-feed bit: 76 mm Hole saw: 152 mm Fastening capacities Wood screw 10 mm x 90 mm Machine screw No load speed (RPM) High (2) 0 - 2,100 min Low (1) 0 - 550 min... -
Page 3: Ec Declaration Of Conformity
Electrical safety Vibration Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs The vibration total value (tri-axial vector sum) deter- with earthed (grounded) power tools. Unmodified plugs mined according to EN62841-2-1: and matching outlets will reduce risk of electric shock. - Page 4 Always wear protective goggles to protect your eyes Battery tool use and care from injury when using power tools. The goggles Recharge only with the charger specified by must comply with ANSI Z87.1 in the USA, EN 166 in the manufacturer. A charger that is suitable for Europe, or AS/NZS 1336 in Australia/New Zealand.
-
Page 5: Tips For Maintaining Maximum Battery Life
It will also away. It may result in loss of your eyesight. void the Makita warranty for the Makita tool and charger. Do not short the battery cartridge: Tips for maintaining maximum Do not touch the terminals with any con- ductive material. -
Page 6: Functional Description
Indicating the remaining battery capacity FUNCTIONAL DESCRIPTION Only for battery cartridges with the indicator CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge CAUTION: Always switch off the tool before... -
Page 7: Overheat Protection
Overheat protection NOTE: When the tool is overheated, the tool stops automatically and the lamp starts flashing. In this This protection works when the tool or battery is over- case, release the switch trigger. The lamp turns off in heated. In this situation, let the tool and battery cool one minute. - Page 8 Speed change Adjusting ring You can select the action mode and adjust the fastening CAUTION: Always set the speed change lever torque with the adjusting ring. fully to the correct position. If you operate the tool with the speed change lever positioned halfway Selecting the action mode between the "1"...
- Page 9 The fastening torque can be adjusted in 21 levels by turning the adjusting ring. Align the graduations with the arrow on the tool body. You can get the minimum fastening torque at 1 and maximum torque at 21. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application.
-
Page 10: Installing Hook
Installing hook OPERATION CAUTION: When installing the hook, always Hold the tool firmly with one hand on the grip and the secure it with the screw firmly. If not, the hook other hand on the handle to control the twisting action. may come off from the tool and result in the personal injury. -
Page 11: Maintenance
Discoloration, deformation or cracks may result. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES ► 1. Blow-out bulb... - Page 12 Makita Europe N.V. Jan-Baptist Vinkstraat 2, 3070 Kortenberg, Belgium Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan 885826-225 www.makita.com 20200828...