Cisco 10BASE-FL Installation And Configuration Manual page 15

Remove the new port adapter from its antistatic container and position it at the opening
Step 9
of the slot. (See Figure 11.)
Carefully align the port adapter carrier between the upper and lower edges of the port
Step 10
adapter slot, as shown in Figure 11.
Caution To prevent jamming the carrier between the upper and lower edges of the port adapter slot, and to
assure that the edge connector at the rear of the port adapter mates with the connector at the rear of the port
adapter slot, make certain that the leading edges of the carrier are between the upper and lower slot edges, as
shown in the cutaway in Figure 11.
Figure 11 Aligning a Port Adapter in a Port Adapter Slot
Carrier
PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration
Installing or Replacing a Port Adapter on a VIP2
Upper edge
Lower edge
15