Cisco 10BASE-FL Installation And Configuration Manual page 14

VIP2 and the 5EFL Port Adapter
Figure 9
Step 6
Step 7
Figure 10
Step 8
14 PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration
Location of Port Adapter Screw (Partial Port Adapter View)
Screw
Remove the screw that secures the port adapter (or blank port adapter).
With the screw removed, grasp the handle on the front of the port adapter (or blank port
adapter) and carefully pull it out of its slot, away from the edge connector at the rear of
the slot. (See Figure 10.)
Pulling a Port Adapter Out of a Slot (Partial Port Adapter View)
If you removed a port adapter, place it in an antistatic container for safe storage or
shipment back to the factory. If you removed a blank port adapter, no special handling is
required; however, store the blank port adapter for potential future use.