Ending A Call; Using Hold And Resume - Cisco Unified Wireless IP Phone 7925G Quick Reference

Tips
• To use any button to answer a call, see
• You can answer an incoming call even when the keypad is locked.
• If you were using an application or service before you answered an incoming call, your application
or service will resume after you end the call.

Ending a Call

To end a call, simply disconnect. Here are some more details.
If you want to...
End the call
Disconnect one call but preserve
another call on the same line

Using Hold and Resume

You can hold and resume calls. When you put a call on hold, the Hold icon
caller ID in the call view.
If the Hold Reversion feature is enabled for your phone, calls that you leave on hold will revert back
to ringing on your phone after a certain length of time. These "reverting" calls remain on hold until
you resume them.
Your phone indicates the presence of a reverting call by:
• Alerting you at intervals with a single ring (or flash or beep, depending on your phone line setting).
• Briefly displaying a "Hold Reversion" message in the status bar at the bottom of the phone screen.
If you want to...
Put a call on hold
Remove a call from
hold on the current line
(using the handset)
Cisco Unified Wireless IP Phone 7925G for Cisco Unified Communications Manager 7.0
Changing Keypad Settings, page
Then...
Choose
Choose EndCall or Options > EndCall. If necessary, remove
the call from hold first.
Then...
1. Make sure the call you want to put on hold is highlighted.
2. Press Hold.
Engaging the Hold feature typically generates music or a beeping
Note
tone.
1. Make sure the appropriate call is highlighted.
2. Press Resume.
, EndCall, or Options > EndCall.
Basic Call Handling
74.
appears next to the
39