Mounting The Camera - D-Link DCS-4802E User Manual

Section 2: Installation

Mounting the Camera

It is highly recommended that you configure and test your camera before mounting it.
Step 1
Place the mounting sticker where you want to position the camera.
Use a 6 mm drill bit to make the required holes approximately 25 mm deep, then
insert the wall anchors into the holes.
If you are running the camera cables through the wall or ceiling, drill a hole
in the center and pull the cables through the hole.
Step 2
Use the screws provided to mount the camera to the wall.
If you are running the camera cables out the side of the camera, guide the
camera cables through the cable channel on the base.
D-Link DCS-4802E User Manual 9