Honeywell HWB2052 Series Owner's Manual page 9

7. inSTALLing yOur WATEr COOLEr fOr THE firST TiME
1. Ensure the unit is unplugged.
2. Remove the Funnel by turning it clockwise or counter-
clockwise depending on the model. Make sure the Hot
Water Funnel (semi-transparent plastic piece) is firmly
sitting on the metal prong of the tank. (Fig.1).
3. Fill water reservoir with tap water full to capacity.
Allow the water to settle into the hot and cold water
tanks for 5 minutes. (Fig. 2)
4. Push each water lever (hot and cold temperature) to
ensure water is running through the unit. (Fig. 3)
5. Plug the dispenser unit into the electrical outlet. Please
review the IMPORTANT SAFETY INSTRUCTIONS and
INSTALLATION GUIDELINES before doing so.
6. Turn ON the hot water switch, wait a couple of minutes
and turn ON the cold water switch. Allow the unit to
reach the minimum cold and hot water temperatures.
This will take approximately 45 minutes and the
indicator lights will turn OFF. (Fig. 4)
7. Test the water temperatures by pushing once again on
the water levers.
8. Turn OFF both hot and cold water switches and unplug
the unit from the electrical outlet.
9. Proceed to drain the water from the faucets one at
a time by pushing on the hot and cold levers until no
more water remains.
10. Move the unit towards the edge of a table or counter
top until the drain cap is exposed from below. Please
make sure to have a water container or bucket
underneath (Fig. 5).
11. Remove the plastic cover using a Phillips screwdriver
(not included). Remove the rubber cover from the
drain pipe to drain the water from the tanks.
12. Close the drain pipe with the rubber cover and secure
the plastic cover back again.
13. Place the Funnel back in its original position.
14. Your unit is ready to be used. Please proceed with the
water bottle loading instructions.
Fig.1
5 MIN
Fig.2
Fig.3
Fig.4
Fig.5
9