Honeywell HWB2052 Series Owner's Manual page 11

8. inSTruCTiOnS fOr LOAding THE WATEr BOTTLE
Loading bottles without spill proof cap
• Remove the cap from the 3 or 5 gallon water bottle
and use a clean cloth to wipe off the neck of the
bottle.
• Carefully lift the bottle (approx. 40 lbs. for the 5 gallon
bottle). Bend your knees to lift the bottle, not your
back. Do not place hands over the opening of the
bottle while placing it on the unit. Please seek help if
you are unable to lift the water bottle.
• Invert the 3 or 5 gallon water bottle over the unit and
gently let the neck of the bottle slide into the funnel,
making sure the prong goes into the neck of the
bottle.
• Allow the water to fill all tanks inside the unit for
approximately one minute.
• Push in on all water levers to make sure water flows
from all faucets.
• Plug the unit back into the electrical outlet.
• Turn ON the hot water switch, wait a couple of minutes
and turn ON the cold water switch. Allow the unit to
reach the minimum cold and hot water temperatures.
This will take approximately 45 minutes and the
indicator lights will turn OFF.
• Test the water temperatures by pushing once again
on the water levers.
• Your water cooler is now ready for use.
Steps To Replace Water Bottles
WArning: Please make sure to turn OFF the unit when the hot and cold water tanks are
empty. Always have water inside the tanks before turning ON any switch.
• Turn OFF the hot and cold water switches.
• Unload the empty bottle from the water cooler.
• Proceed to load the new bottle following the INSTRUCTIONS FOR LOADING THE WATER
BOTTLE.
11