Embedded Terminals with Profibus DP
Master
Fastening the cover
1. Check that the seal of the cover is not damaged.
2. Position the cover properly and fasten the screws with the corresponding
tightening torque (refer to
Cable grommets ate the Embedded Terminal VEP 30.5DPU...
To maintain the degree of protection IP 54, use only cable grommets that fit
●
the cable cross-sections for cable bushing. Also refer to the following table:
Cable grommet name
(Assembling kit/putty)
QT4
QT5
QT6
QT7
QT8
QT11
QT12
QTB
Tab. 10-3: Cable diameter and corresponding cable grommets
10.4.1 Mounting at standardized VESA support arm
Observe the minimum bending radius of the cables used.
Use appropriate cable material (sufficient bending and torsional
strength).
DOK-CONTRL -VEP*XX.5***-IT01-EN-P
Mounting, demounting and electric installation
tab. 10-2 "Tightening torques" on page
Cable diameter
4-5 mm
5-6 mm
6-7 mm
7-8 mm
8-9 mm
11-12 mm
12-13 mm
Dummy sleeve
Bosch Rexroth AG
20).
23/41