Overload Protection; Overheat Protection; Overdischarge Protection - Makita DLM460PG2 Instruction Manual

Cordless lawn mower
Table of Contents

Advertisement

To install the battery cartridge;
1.
Pull up the locking lever, and then open the battery cover.
► 1 . Battery cover 2. Locking lever
2.
Align the tongue on the battery cartridge with the slot on the
mower then slide the cartridge until it locks in place with a little click.
► 1 . Battery cartridge
3.
Insert the lock key in the place shown in the figure
as far as it will go.
► 1 . Lock key
4.
Close the battery cover and push it until it is
latched with the locking lever.
To remove the battery cartridge from the mower;
1.
Pull up the battery cover locking lever and open
the battery cover.
2.
Pull out the battery cartridge from the mower while
sliding the button on the front of the cartridge.
3.
Pull out the lock key.
4.
Close the battery cover.
Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
1
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto-
matically stop during operation if the tool or battery is
placed under one of the following conditions:

Overload protection

When the battery is operated in a manner that causes
it to draw an abnormally high current, the tool automati-
cally stops and the main power lamp blinks in green. In
this situation, turn the tool off and stop the application
that caused the tool to become overloaded. Then turn
2
the tool on to restart.

Overheat protection

When the tool or battery is overheated, the tool stops
automatically and the main power lamp lights up in red.
In this case, let the tool and battery cool before turning
the tool on again.
1

Overdischarge protection

When the battery capacity is not enough, the tool stops
automatically and the main power lamp blinks in red. In
this case, remove the battery from the tool and charge
the battery cartridges or change the battery cartridges
to fully charged ones.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
1
► 1 . Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
9 ENGLISH
1
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dlm461Dlm460Dlm460pt4Dlm460pt2Dlm460z

Table of Contents