Makita DLS211ZU Instruction Manual page 29

1
► 1. Guide fence 2. Crown molding stopper
(a) (b)
1. Inside corner 2. Outside corner
Table (C)
– Molding
position in
the figure
For inside (a)
corner
(b)
For outside (c)
corner
(d)
(c) (d)
1 2
Miter angle Finished
piece
Right 45° Save the right
side of blade
Left 45° Save the left
side of blade
Save the right
side of blade
Right 45° Save the left
side of blade
Cutting aluminum extrusion
3
4
2
► 1. Vise 2. Spacer block 3. Guide fence 4. Aluminum
extrusion 5. Spacer block
When securing aluminum extrusions, use spacer blocks or pieces
of scrap as shown in the figure to prevent deformation of the alumi-
num. Use a cutting lubricant when cutting the aluminum extrusion
to prevent build-up of the aluminum material on the blade.
WARNING:
num extrusions. Thick or round aluminum extrusions can be diffi-
cult to secure and the work may loosen during the cutting operation
which may result in loss of control and serious personal injury.
Special Max Width Cutting
Capacities Technique
The maximum cutting capacity of width can be achieved
by following the steps below:
For the maximum cutting width of this tool, refer to the cutting
capacities for special cuttings in the SPECIFICATIONS section.
1. Set the tool at 0° or 45° miter angle and make sure that the
turn base is locked. (Refer to the section for miter angle adjustment.)
2. Remove both right and left upper fences temporar-
ily and set aside them.
3.
Cut a platform to the dimensions indicated in the
figure using a 38 mm thick, flat stock material such as
wood, plywood or particle board.
3
► 1. 0° Miter angle: Over 450 mm 2. 45° Miter angle:
Over 325 mm 3. 38 mm 4. Over 760 mm
29 ENGLISH
1
2
5
Never attempt to cut thick or round alumi-
1
2
4