Makita DRT50ZJ Instruction Manual page 17

1
► 1 . Workpiece 2. Bit 3. Guide roller
Using the tool with the tilt base
The tilt base is convenient for chamfering. Loosen the
wing screws, then tilt the tool at the desired angle, and
then tighten the wing screws.
Firmly clamp a straight board to the workpiece and use it as a guide
against the tilt base. Feed the tool in the direction of the arrow.
► 1 . Wing screw
Using the tilt base plate with the
trimmer base
To use the trimmer base with a square base plate, remove the base
plate from the tilt base, and then attach it to the trimmer base.
► 1 . Tilt base plate 2. Trimmer base plate
2
3
1
1 2
Using the tool with the offset base
The offset base is convenient for work in a tight area
such as a corner.
Using the trimmer base with the
offset base plate and grip
The offset base plate can also be used with a trimmer
base and a grip attachment (optional accessory) for
more stability.
1.
Loosen the screws on the base plate, then remove
the base plate from the offset base.
► 1 . Offset base plate 2. Trimmer base plate
2. Attach the offset base plate to the trimmer base by
tightening the screws.
3.
Attach the grip attachment and the bar type grip to
the offset base plate by tightening the screws.
17 ENGLISH
1 2