Makita DRT50ZJ Instruction Manual page 10

Installing or removing the trimmer
base
1.
Open the lock lever of the trimmer base, then
insert the tool into the trimmer base aligning the groove
on the tool with the protrusion on the trimmer base.
► 1 . Lock lever
2.
Close the lock lever.
3. Attach the dust nozzle to the trimmer base, and
then tighten the thumb screw.
► 1 . Dust nozzle 2. Thumb screw
1
1 2
To remove the base, follow the installation procedure
in reverse.
CAUTION:
When using the tool with the trim-
mer base, be sure to install the dust nozzle on the
trimmer base.
Installing or removing the tilt base
Optional accessory
1. Open the lock lever of the tilt base, then insert the
tool into the tilt base aligning the groove on the tool with
the protrusion on the tilt base.
► 1 . Lock lever
2.
Close the lock lever.
To remove the base, follow the installation procedure
in reverse.
10 ENGLISH
1