Makita GA9070 Instruction Manual page 10

The loop handle can be more comfortable than the original side
grip for some applications. To install the loop handle, mount it
onto the tool as illustrated and tighten two bolts to fix it.
To remove the loop handle, follow the installation proce-
dure in reverse.
1
► 1. Loop handle 2. Bolt 3. Gripping area
Installing or removing wheel guard
(For depressed center wheel, flap disc,
flex wheel, wire wheel brush / abrasive
cut-off wheel, diamond wheel)
WARNING:
When using a depressed center
wheel, flap disc, flex wheel or wire wheel brush,
the wheel guard must be fitted on the tool so that
the closed side of the guard always points toward
the operator.
When using an abrasive cut-off
WARNING:
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
(In some European countries, when using a diamond
wheel, the ordinary guard can be used. Follow the
regulations in your country.)
For tool with locking screw type
wheel guard
Mount the wheel guard with the protrusions on the wheel guard
band aligned with the notches on the bearing box. Then rotate
the wheel guard to such an angle that it can protect the opera-
tor according to work. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
1
2
► 1. Wheel guard 2. Bearing box 3. Screw
3
2
3
For tool with clamp lever type wheel
guard
Optional accessory
WARNING:
on the tool so that the closed side of the guard
always points toward the operator.
Loosen the nut, and then pull the lever in the direction
of the arrow.
2
► 1. Nut 2. Lever
Mount the wheel guard with the protrusions on the
wheel guard band aligned with the notches on the bear-
ing box. Then rotate the wheel guard to such an angle
that it can protect the operator according to work.
1
2
► 1. Wheel guard 2. Bearing box
► 1. Wheel guard
10 ENGLISH
The wheel guard must be fitted
1
1