Hitachi IJ RX2-SD160 Instruction Manual page 208

No.
49 Print Overlap Fault
Print Head Cover
50
Open
Detector Position
51
Improper
Target Sensor Time
52
Out
Target Spacing Too
53
Close
Print Data
54 Changeover In
Progress S
Ink Self Life
55
information
56 Blank Print Items
Excessive Format
57
Count
Print Data
58 Changeover In
Progress M
Print Data
59 Changeover In
Progress V
Communication
60
Buffer Fault
9-6 ●On-screen message descriptions
Message
The print target detecter signal for the next
target arrived during the print operation for
the current target.
The print head cover is open.
The print target detecter signal turned OFF
before print start during printing at repeat
print setting.
The print target detecter signal was ON
longer than the timeout setting of Target
Sensor Timer.
There are 5 or more print target detector
signal turned ON before print start during
printing at No repeat print setting.
A print operation was requested while the
print data was being changed.
Replacement of ink is recommended.
The print items are not properly set up.
A column has more than 8 print format
types (the number of lines, line spacing,
character size, character spacing, bold
charcter and bar code).
A print operation was requested while the
print data was being changed.
A print operation was requested while the
video data was being changed.
The print contents are not in the
communication buffer.
Meaning of message Remedy
● Increase the spacing between
products.
● If the target signal is
chattering, use sensor filter
setting. ( 4.14.1).
● Remove the cover and then
hit the Clear key.
● If a magnetic substance is
used to fix the cover,
it must be replaced with
nonmagnetic resin (metal).
● Move the print target detecter
closer to the print head.
● If the target signal is
chattering, use sensor filter
setting.
● Check the data entered.
● If the target is stopped in front
of the sensor, move the target.
● Change the Target Sensor
Timer setting.
( 4.14.1).
● Move the print target detecter
closer to the print head.
● If the target signal is
chattering, Use Sensor filter
setting.
● Change of timing either print
data change or print start.
● Use ink within its expiration
dae at replacement.
● Confirm ink of number on
unit information screen.
● Contact your nearest local
distributor.
● Change the print data.
● Perform setup so that the
number of print format types
does not exceed 8.
● Change timing of either print
data change or print start.
● Adjust either the encoder
frequency or the pulse rate
division factor.
● Change timing of either print
data change or print start.
.● Adjust the print and
communication timing.