Makita DHW080ZK Instruction Manual page 11

To introduce water into the hose, remove the nozzle
from the trigger gun and switch on the high pressure
washer while the trigger is squeezed. Once water is
ejected stably from the trigger gun, release the trigger
and attach the nozzle for your purpose.
1
► 1. Trigger gun
NOTE: When water is not ejected, detach the suction
hose set and soak it in water. Then reconnect it to the
high-pressure washer.
► 1. Suction hose set
When using the container as a water
tank
You can use the container supplied with the high pres-
sure washer (country specific) as a water tank.
1.
Empty the container and feed water in it.
► 1. Full water level line
NOTICE:
Do not feed water above the full water
level line.
NOTICE:
The lid of the container is not a tight
seal type. Be careful not to spill the water in the
container when carrying.
2. Disconnect the filter case from the hose of the
suction hose set.
1
► 1. Hose 2. Filter case
3. Remove the cap on the feed-water inlet and pass
the suction hose set through the inlet as illustrated.
2
1
3
4
► 1. Cap 2. Cap holder 3. Feed-water inlet 4. Suction
hose set
1
NOTE: The cap on the feed-water inlet can be rest on
the cap holder.
11 ENGLISH
2
1