Table of Contents
Advertisement
Trigger operations
Pull the trigger to eject a water jet. The jet continues as
long as the trigger is squeezed.
The trigger can be locked for safe handling of the trigger
gun. To lock the trigger, pull out the stopper and hook it
to the groove on the grip.
► 1. Trigger 2. Stopper 3. Groove
NOTICE:
To avoid mechanical error in the pres-
sure switch, always leave a two-second interval
between trigger operations.
Safety valve
This appliance is equipped with a safety valve that
prevents undue overpressure. When the trigger is
released, the valve opens and the water recirculates
through the pump inlet.
CAUTION:
Do not tamper with or adjust the
safety valve setting.
Supplying water from a tank/
reservoir
You can supply water from a tank or reservoir instead
of a faucet.
Replace the water hose connector with the suction hose
set. When connecting the suction hose set, disconnect
the filter case from the hose and attach the filter case to
the inlet of the high pressure washer. Then, connect the
1
hose to the filter case.
NOTE: When removing/connecting the hose from/to
2
the filter case, turn the sleeve while holding the hose
so that the hose does not rotate with the sleeve.
3
1
4
7
► 1. Tank/reservoir 2. Suction hose set 3. Water hose
connector 4. Hose 5. Filter case 6. Inlet on the high
pressure washer 7. Hose band 8. Sleeve
CAUTION:
filter case, be careful not to hurt your hand by the
hose band.
NOTICE:
NOTICE:
height between the inlet of the high pressure
washer and the water surface. Otherwise, the high
pressure washer will be unable to take the water up
into the pump.
10 ENGLISH
2
5
6
8
When attaching the sleeve to the
Always use Makita's suction hose set.
Always keep 1 m (3.28 ft) or less in
3
Advertisement
Table of Contents
