Table of Contents
Advertisement
Troubleshooting
The following problems do not always denote a broken this unit. Perform the checks listed below before calling
service.
■ VCR/DVD
• No power
• The Remote does not work.
• No picture
• Dew
■ VCR
• TV will not tune in to the VCR.
• Auto Installation screen does not
appear when the VCR is switched on
or Auto Installation is not complete.
• Display is not working.
• No picture appears.
• Playback picture is snowy.
• Playback/Recording does not play
back in Stereo.
• Tape is automatically ejected when
pressing Æ Æ Æ Æ Æ REC or TIMER ON/OFF.
GB-96
DVNC65SE096_101.pm6
Downloaded from:
http://www.usersmanualguide.com/
Problem
• Is the power cord connected properly?
• Is the power cord firmly plugged into the power outlet?
• One of the safety mechanisms may be operating. In this event,
• Are the batteries loaded correctly?
• Are the batteries flat?
• Is the signal emitter on the Remote pointing at the Unit?
• Is the Remote too far from the Unit, or is there any obstacle between
• Did the VCR/DVD CHANGE Switch change correctly?
• Did the VCR/DVD SELECTOR change correctly?
• See page 6 for information.
Problem
• Check all the cables are correctly connected.
• Check your TV manual for correct tuning of your TV.
• Reset the VCR and complete AUTO INSTALLATION again. (Refer
• Make sure the power cord is plugged in.
• Make sure the wall socket has power .
• Make sure the TV is set to the video channel.
• Check all connecting cables.
• Adjust the tracking using CH '/".
• Try another tape.
• The video heads may have been contaminated - refer to a SHARP
• Ensure the VCR is connected to a stereo TV with a SCART lead.
• Programme may not carry stereo.
• The record-protection tab has been removed from the cassette.
96
Suggested Solution
unplug the Unit from the power outlet briefly and then plug it in
again.
the Remote and the Unit?
Possible Cause/Solutions
to VCR Reset on page 38.)
Service Facility.
9/10/02, 10:31 am
Advertisement
Table of Contents
