Table of Contents
Advertisement
AT+CLIP
When receiving a call, this command allows to identify the calling number. With the command
AT+CLIP? It is possible to obtain the status of the "CLIP Service" in the network. The caller ID is
displayed after any RING message.
Command
AT+CLIP=0
AT+CLIP=1
AT+CLIP?
AT+CLIP=?
Default: AT+CLIP=0
<n>
CLIP Service status in the network (reading only)
0
CLIP Service not available
1
CLIP Service available
2
Service Status: Unknown (no network...)
AT+CLIR
This command allows to hide the Calling Line Identification to the remote device.
Note: Independently from the setting of AT+CLIR, it is possible to add an "i" small letter at the end
of the calling string to present the CLI to the remote user (e.g. ATD0123456789i); or the letter "I"
capital letter to hide the CLI (e.g. ADT0123456789I)
Command
AT+CLIR=0
AT+CLIR=1
AT+CLIR=2
AT+CLIR?
AT+CLIR=?
Default: AT+CLIR=0
<n>
CLIR Service status in the network (reading only)
0
CLIR Service not available
1
CLIR Service available
2
Service Status: Unknown (no network...)
3
CLIR Service temporary suspended
4
CLIR Service temporary available
AT+CMEE
This command enables the report +CME ERROR: <err> and +CMS ERROR <SMSerr> with the
indication of the error code, instead of a generic answer. (See Appendix A for error codes).
Command
AT+CMEE=0
AT+CMEE=1
AT+CMEE?
Default: AT+CMEE=0
Calling Line Identification (CLI)
Possible answers
OK
OK
+CLIP: 0,<n>
+CLIP: (0,1)
Calling Line Identification restriction (CLI)
Possible answers
OK
OK
OK
+CLIR: 0,<n>
+CLIR: (0-2)
Report Mobile Equipment errors
Possible answers
OK
OK
+CMEE: 0
Action
CLI displaying is disabled
CLI displaying id enabled
Shows the current settings and the
CLIP Service state
Shows the available settings
Action
CLI presentation depends on the CLIR
Sevice status.
CLI is not displayed
CLI is displayed
Shows the current settings and CLIR
Service status
Shows the available settings
Action
Report disabled
Report enabled
Shows the current settings
25
Advertisement
Table of Contents
