When The Busy Terminal Becomes Idle; To Cancel; Timed Queuing (Outside Line Only); To Make/Answer A Call During Call In Progress - NEC UNIVERGE DT930 User Manual

WHEN THE BUSY TERMINAL BECOMES
IDLE
1.
The terminal which has set Call Back is alerted by
ring.
When busy terminal becomes idle or the
terminal that did not answer initiates or
answers a call or accesses a feature and then
becomes idle, the setting terminal is alerted by
ring.
Call Indicator Lamp flashes.
Line key lamp flashes green.
2.
Lift the handset.
The extension number that was busy/no
answer is automatically dialed.
Line key lamp lights green.

TO CANCEL

This feature is available only for the
terminal that is set by system data
setting at initial installation. This feature
cannot be canceled by Soft key.
1.
While the terminal is set Call Back feature,
Call Back feature key lamp lights red.
2.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red.
Line key lamp lights green.
3.
Press Call Back feature key.
You will receive a service set tone.
Call Back feature key lamp goes off.
4.
Press Speaker key.
Speaker key lamp goes off.
Line key lamp goes off.
TIMED QUEUING (OUTSIDE LINE
ONLY)
When a user originates an outgoing trunk call and
the called party is busy or does not answer, the
caller can set the Timed Queuing. When this feature
is set, the trunk seizure is repeated and the number
is dialed again after a predetermined time interval.
The feature key is set by system data
setting at initial installation. For details,
please contact the system
administrator.
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red.
2.
Dial Outside Line access code.
3.
Dial desired number.
You will receive a busy tone or a ring no
answer from distant end.
4.
Press Call Back feature key.
Line key lamp flashes green.
5.
Leave speaker on.
The desired number is automatically redialed.
6.
Start conversation with called party.
Busy tone is sent to the calling party
when the call is made to the extension
that is in Timed Queue mode.
TO MAKE/ANSWER A CALL
DURING CALL IN PROGRESS
This feature permits a user to hold a call in progress
by pressing the Call Hold feature key. This line can
then be used for originating another call or
answering another incoming call. After finishing
another call and replace the handset, the original
held call rings back.
It is required that the dedicated feature
key other than fixed feature key (Hold)
shall be set by system data setting at
initial installation. For details, please
contact the system administrator.
1.
While call in progress,
The Line key lamp lights green.
2.
Press call hold feature key.
Call hold feature key lamp doesn't light.
The called party will receive a hold tone.
69
FEATURE OPERATION