Figure 15-16 M4 Screw Position - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

How to Install
Procedure 15-12 How to Extract the Module Cage from MTS 2
1
2
3
4
15-40
Remove all RF cables (RX, TX, and GPS if mounted).
Disconnect all cables between the module cage and the Junction Panel.
Remove any CAN Bus cables going to and from the Filter(s)
Remove the filter section by
• Removing 6 pcs. M4 screws using TORX20.
• Remove the special Ground screw using a normal screw driver.
Filter modules need to be removed in order to have access.
The Ground screw should be reattached after removal of the filter section.

Figure 15-16 M4 Screw Position

Chapter 15: Expansion Options
6802800U74-N September 2009