Figure 4-34 Mts Lvd Kit Backplate Plugs; Figure 4-35 Mounting The Mts Lvd Kit - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS LVD Kit Installation
Procedure 4-9 How to Install the MTS LVD Kit (Continued)
4
5
6
7
8
9
10
4-34
Flip the backplate by hand, and insert the 2 rivet plugs as in Figure below.

Figure 4-34 MTS LVD Kit Backplate Plugs

Mount the LVD housing to the intended location, i.e. on top of the MTS as shown in Figure
below, using a hammer for snapping in the screw.

Figure 4-35 Mounting the MTS LVD Kit

The plug fits into any Ø7mm hole. Center diameter between the two rivet plugs
is 90mm
Locate the Power connector on the Site Controller and disconnect this.
Plug the LVD controller cable into the now empty power slot and plug the existing power plug
just removed in step above into the empty socket on the controller cable.
Secure LVD controller cable using cable ties to the best possible routing toward the LVD relay.
Avoid any potential damages on cable due to sharp edges etc.
Switch power ON.
Check if the relay is engaged, when MTS 4 is powered up.
Chapter 4: Hardware Installation
6802800U74-N September 2009