GE ARITECH FP400 Series User Manual page 6

14. Sounders ON
The sounders have been activated. If the LED flashes the sounders will be activated after
the programmed delay.
15. Sounders Silence
The sounders have been silenced by pressing the Sounders Silence / Disable button.
16. Test
A zone is in test mode.
1.1.2 Accoustic indicators
Alarm indicator: Continuous internal buzzer.
Fault indication: Intermittent internal buzzer.
1.1.3 Control panel buttons
A. Zone (Z1, Z2 etc.)
Enable / disable a zone. When a zone is disabled the LED is ON.
B. Silence Buzzer
Silences the internal buzzer and activates the corresponding LED.
C. Reset
Restarts the system. Any fault or alarm that has not been resolved will be highlighted
again.
D. Sounder ON
Activates the sounder outputs. If a delay is programmed it may be disabled by pressing
this button from level 1.
E. Sounders silence / Disable
Stops the sounder outputs if they are activated and activates the corresponding LED. If
the sounders are not active they may also be disabled by pressing this button for
approximately 2 seconds. To enable sounders press the button again.
F. Test
Tests the internal buzzer and unit LEDs. If pressed together with a zone button the zone
is placed into test mode and the corresponding LED is activated.
G. ON/OFF (key)
Enables and disables the keyboard.
Operating modes
1.1.4
Standby
6 FP400 Series User Guide