Calibrating Depth Scale; Setting Fence Stops - Grizzly G0634X Owner's Manual

Calibrating Depth
Scale
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
Items Needed
Straightedge ...................................................... 1
Phillips Screwdriver ........................................... 1
To calibrate depth scale:
DISCONNECT MACHINE FROM POWER!
1.
Set outfeed table height as described in
2.
Setting Outfeed Table Height on Page 44.
Use straightedge to help adjust infeed table
3.
exactly even with outfeed table, as shown in
Figure 72.
Straightedge
Outfeed
Figure 72. Infeed table even with outfeed table.
Using screwdriver, adjust scale pointer to
4.
zero (see Figure 73).
Depth
Scale
Figure 73. Depth scale adjusted to "0" position.
-50-
Qty
Infeed
Depth Scale
Pointer

Setting Fence Stops

The fence stops simplify the task of adjusting the
fence to 45˚ and 90˚.
Items Needed
45° Square......................................................... 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Wrench 10mm ................................................... 1
Wrench 12mm ................................................... 1
Hex Wrench 3mm .............................................. 1
Hex Wrench 4mm .............................................. 1
Setting 90° Fence Stop
Loosen lock nut on 90° fence stop screw
1.
shown in Figure 74, and loosen fence tilt
knob.
Lock Nut
Figure 74. Adjusting fence to 90°.
Place 90° square against table and fence,
2.
and adjust stop screw so fence is set exactly
at 90°.
Tighten lock nut.
3.
Setting 45° Fence Stop
Loosen fence tilt knob and position fence
1.
against 45° stop bolt.
Model G0634X (Mfd. Since 11/20)
Qty
90˚Stop Screw