Preparation Before The Post-Installation Adjustment Operation - Yamaha SIGMA-G5SII Service Information

(4) Other
(4.1) The component thickness is measured not using the linear measure, but using
(4.2) The safety door lock operation tab is moved on the lower right of the operation
(4.3) The position adjustment for the feeder cart detection sensor is not required any
(4.4) The X-axis driving method has been changed to the ball screw driving.
(4.5) The Machine Inside CPK Measurement (Self-Calibration) menu has been

1.4.4.2. Preparation before the Post-Installation Adjustment Operation

(1) Perform the running-in operation for about one hour after the machine installation.
(1.1) Any nozzles are not attached in the running-in operation. Dummy nozzles are
(1.2) When any multi-functional head is to be used, the nozzles appropriate for the
Note:
Save the backup data to the PC running the NT-100 software before and after the teaching
operations.
Backup Procedure before the Work
(1) Create "Before" and "After" folders in any location (desktop, etc.) in the service PC.
(2) Register the machine to be taught in the Device Manager in the NT-100 (network
terminal).
(3) Select the above "Before" folder using the "Path" in the "Sys. Setting" window in
the main menu of NT-100.
(4) Communicate with the machine to be taught and receive the "Sys. Setting" data.
Backup Procedure after the Work
 It is available also after the accuracy measurement (CPK measurement).
(1) Select the "After" folder using the "Path" in the "Sys. Setting" window in the main
menu of NT-100.
(2) Communicate with the subject machine to receive the "Sys. Setting" data.
the side view camera.
window as for the SIGMA-F8 machines.
more.
Because the cover is easily deformed, the instructions for avoiding pressing the
cover, are required for the user.
Also, the X-axis ball screw quick lubrication training is required when the
machine is delivered.
added.
registered.
* Set the nozzles required for the pattern program, on the data, in the nozzle
arrangement selection window. The attachment of the actual nozzles is not
required.
pattern program should be setup in the nozzle stocker.
Service Information
SI1705004E-00=SIGMA-G5SII Service Manual
24/273
For Service Engineer