Disengaged Latch Sensor Amplifier Adjustment - Yamaha SIGMA-G5SII Service Information

4.19.3. Disengaged Latch Sensor Amplifier Adjustment

(1) For the Disengaged Latch Detection, position it on the feeder base and set it so that the
light is received.
(2) First, set the power tuning setting value to
* Refer to the following figure for the amplifier adjusting procedure.
Set the control output to
Press the output switch button and turn ON the L/D indicator lamp
Percent Tuning Mode Setting
Press the mode change button for 3 seconds or more and set the function.
 Function Selection
⇒Press the +/- button to set it to the following value and determine the value using the
mode change button.
 Detection Function
⇒Press the +/- button to set it to the following value and determine the value using the
mode change button.
 DPC Function
⇒Press the +/- button to set it to the following value and determine the value using the
mode change button.
 Timer Function
⇒Press the +/- button to set it to the following value and determine the value using the
mode change button.
" 2000 " . At that time, do not set up the feeder.
" "
Back Lighting Type .
189/273
For Service Engineer
Service Information
" "
L .
SI1705004E-00=SIGMA-G5SII Service Manual