CIPer
MODEL 50 CONTROLLER – INSTALLATION AND COMMISSIONING INSTRUCTIONS
TM
• Configure the network as desired by applying the available options displayed.
• To reset the controller to factory defaults, press F in the Boot menu.
ATTENTION: Resetting the controller to its factory defaults will result in the following:
• The station will be deleted.
• The platform credentials will be deleted.
• The IP settings will be reset to the factory defaults (see section "Default IP Addresses of Ethernet
Interfaces 1 and 2").
RECOMMENDATION: Before leaving (closing) the terminal program, go to "Network Setup" and enter the
desired IP settings.
• Reset the controller by entering Y.
25
31-00233-02