Enable Or Disable - Output Groups - Honeywell SMX-AUS User Manual

User's Guide SMX-AUS

7.2.4 ENABLE OR DISABLE - OUTPUT GROUPS

Fig. 29: Enable or Disable the Output Groups
30
You can enable or disable an output group in the panel.
1. Tap OUTPUT GROUPS.
2. All output groups in the panel are listed.
3. Tap ENABLE to enable the output group or tap DISABLE to disable the output group.
•
State information about the Fault Relays and the Other Relays & Controls can only
be viewed.
• Programmable relay is available only if the onboard relay is not configured as an
output for supervisory condition.
• Fan Controls option is available only when at least one Fire Fan Control group is
configured.
•
Alarm Routing Equipment and Relay Card-Programmable Relay 8 outputs are
available only if the Relay I/O Card is fitted and configured.
•
The inputs and outputs on the Alarm Routing Equipment interface cannot be
individually disabled. If ARE is disabled, the inputs and outputs are also disabled
(except for the Disabled relay and the Alarm Feedback input).
NS-MN-0032 / 11.2020