Honeywell SMX-AUS User Manual page 36

User's Guide SMX-AUS
8.1.2.1 LED Test
Fig. 39: Testing LEDs
8.1.2.2 Buzzer Test
Fig. 40: Testing Buzzer
36
The panel will test all the system status LED indicators one after another, and then repeat the
test again and again. It can only be stopped manually.
Perform the following steps to run the LED Test:
1. In RUN TEST screen, tap LED TEST.
2. The Testing LEDs... screen opens to show the progress of the LED test. During the test LEDs
on the panel also blinks one after another.
3. After the test is complete, tap STOP to come out of the LED Test.
The LED Test is a loop test, it keeps recurring if you do not stop it.
Perform the following steps to run the Buzzer Test:
1. In the RUN TEST screen, tap BUZZER TEST.
2. The Testing Buzzer... screen opens to show the progress of the Buzzer Test. During the test,
the buzzer on the board hoots.
The Buzzer is a loop test, it keeps recurring if you do not stop it.
NS-MN-0032 / 11.2020