Tools Needed; Electrical Requirement - Black & Decker BDFH44M Instruction Manual

INSTALLATION INSTRUCTIONS

TOOLS NEEDED

Phillips screwdriver
Adjustable wrench
that opens to 1" (25mm)
ELECTRICAL REQUIREMENTS
ELECTRICAL CONNECTIONS
You will need to purchase a UL dryer power cord kit, not provided with the unit
unless the washer will be direct wired.
Turn off the circuit breaker.
The wiring diagram is located on the back board of the unit.
- The improper connection of the equipment grounding conductor can result in the
risk of electric shock. Check with a qualified electrician or serviceman if you are
in doubt as to whether your dryer is properly grounded. Do not modify the plug
provided with your dryer. If it doesn't fit the outlet, have a proper outlet installed by
a qualified electrician.
- To prevent unnecessary risk of fire, electrical shock, or personal injury, all wiring
and grounding must be done in accordance with local codes, or in the absence of
local codes, with the National Electrical Code, ANSI/NFPA No. 70 - Latest Revision
(for the U.S.) or the Canadian Electrical Code CSA C22.1 - Latest Revisions and
local codes and ordinances. It is your responsibility to provide adequate electrical
services for your dryer..
An individual branch (or separate) circuit serving only your dryer is recommended.
DO NOT USE AN EXTENSION CORD
The dryer requires a 240 volt, 60Hz AC approved electrical service.
The electric service requirements can be found on the data label located on the back.
A 30-ampere fuse or circuit breaker on both sides of the line is required.
- If a power cord is used, the cord should be plugged into a 30 - ampere receptacle.
- The power cord is NOT provided with U.S. electric model dryers.
Flat screwdriver
Cutting kinfe
Level
Tape measure
Pliers
Page 21