Makita KP001G Instruction Manual page 10

3. Untighten the screws from the conventional planer
blade, and then remove the adjusting plate.
Fig.8
► 1 . Screws 2. Conventional planer blade 3. Adjusting
plate
Installing conventional planer blades
1. Set a conventional planer blade onto the blade
gauge, aligning its cutting edge along the guide wall on
the blade gauge horizontally.
2
Fig.9
► 1 . Conventional planer blade 2. Blade gauge
3. Cutting edge 4. Guide wall
2. Place the adjusting plate over the conventional
planer blade, and then slightly tighten the screws.
3. Push the adjusting plate forwards until its position-
ing guide neatly and entirely fits along the rear side wall
of the blade gauge.
2
3
1
1
4
4. Hold the adjusting plate where it is and tighten the
screws to secure it in place.
2
3
1
Fig.10
► 1 . Adjusting plate 2. Conventional planer blade
3. Screw 4. Positioning guide 5. Rear side wall
3
6. Blade gauge
5. Clean out all the wood chips and foreign matters
adhering to the drum and conventional planer blade.
6. Slip the positioning guide of the adjusting plate into
the guide groove in the drum, and then place the drum plate
over the conventional planer blade (with adjusting plate).
7. Cross-tighten all the installation bolts evenly with
the box wrench.
Fig.11
► 1 . Positioning guide 2. Adjusting plate 3. Guide
groove 4. Drum 5. Drum plate 6. Conventional
planer blade 7. Installation bolt
10 ENGLISH
4
6 5
7
5
2
1
6
4
3