Switch Action - Makita LS1018 Instruction Manual

1
2
3
► 1. Pointer 2. Release button 3. Bevel scale
Tilt the saw blade until the pointer points to the desired
angle on the bevel scale. Then tighten the lever clock-
wise firmly to secure the arm.
• When changing bevel angles, be sure to position
the kerf boards appropriately as explained in the
"Positioning kerf boards" section.
CAUTION:
• After changing the bevel angle, always secure
the arm by tightening the lever clockwise.
NOTICE:
• When tilting the saw blade be sure the handle is
fully raised.
• When changing bevel angles, be sure to position
the kerf boards appropriately as explained in the
"Positioning kerf boards" section.
Slide lock adjustment
► 1. Locking screw
To lock the slide pole, turn the locking screw clockwise.

Switch action

1
► 1. Lock-off button 2. Switch trigger 3. Hole for
padlock
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
• Before plugging in the tool, always check to
see that the switch trigger actuates properly
and returns to the "OFF" position when
released. Do not pull the switch trigger hard
without pressing in the lock-off button. This
can cause switch breakage. Operating a tool
with a switch that does not actuate properly
can lead to loss of control and serious personal
injury.
A hole is provided in the switch trigger for insertion of
padlock to lock the tool off.
WARNING:
• Do not use a lock with a shank or cable any
smaller than 6.35 mm in diameter. A smaller
shank or cable may not properly lock the tool in
the off position and unintentional operation may
occur resulting in serious personal injury.
• NEVER use tool without a fully operative
switch trigger. Any tool with an inoperative
switch is HIGHLY DANGEROUS and must be
repaired before further usage or serious per-
sonal injury may occur.
1
• For your safety, this tool is equipped with a lock-
off button which prevents the tool from unin-
tended starting. NEVER use the tool if it runs
when you simply pull the switch trigger without
pressing the lock-off button. A switch in need of
repair may result in unintentional operation and
serious personal injury. Return tool to a Makita
service center for proper repairs BEFORE fur-
ther usage.
• NEVER defeat the lock-off button by taping
down or some other means. A switch with a
defeated lock-off button may result in uninten-
tional operation and serious personal injury.
10 ENGLISH
2
3