Makita DTD170 Instruction Manual page 8

Impact force grade displayed
on panel
Max
Hard
Medium
Soft
T mode
NOTE:
NOTE:
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
NOTE:
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
Fig.11
socket bit.
For tool with shallow driver bit hole
Maximum blows
-1
3,800 min
-1
3,600 min
-1
2,600 min
-1
1,100 min
-1
2,600 min
-1
3,800 min
Use only these type of driver
bit. Follow the procedure
1. (Note) Bit-piece is not
necessary.
Purpose
Tightening with the maximum
force and speed.
Tightening with less force and
speed than Max mode (easier
to control than Max mode).
ing is needed.
Tightening with less force to
avoid screw thread breakage.
Tightening when speed and
Tightening screws with better
control.
For tool with deep driver bit hole
Procedure 1
For tool without one-touch type sleeve
Fig.12: 1. Driver bit 2. Sleeve
To install the driver bit, pull the sleeve in the direction of
the arrow and insert the driver bit into the sleeve as far
as it will go.
Then release the sleeve to secure the driver bit.
For tool with one-touch type sleeve
To install the driver bit, insert the driver bit into the
sleeve as far as it will go.
8 ENGLISH
Example of application
Tightening underwork mate-
rials, tightening long screws,
tightening bolts.
Tightening underwork mate-
rials, tightening long screws,
tightening bolts.
-
plaster boards.
Tightening sash screws, tight-
ening small screws such as M6.
Tightening self drilling screws.
Tightening long screws.
To install these types of driver
bits, follow the procedure 1.
To install these types of driver
bits, follow the procedure 2.
(Note) Bit-piece is necessary
for installing the bit.