Makita DTD155 Instruction Manual page 7

NOTE:
When the lamp lights up by pulling the switch trigger,
the lamp status is ON. When the lamp does not come
on, the lamp status is OFF.
NOTE:
for one minute, and then the LED display goes off. In
this case, cool down the tool before operating again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Changing the impact force
Fig.8: 1. Hard 2. Soft 3.
steps 5. Button
You can change the impact force in three steps: hard,
Every time the button is pressed, the number of blows
changes in three steps.
Impact force grade displayed
on panel
Hard
Soft
NOTE:
impact force and speed are the same as hard mode.
NOTE:
NOTE: While pulling the switch trigger, the impact force grade cannot be changed.
4. Changed in three
Maximum blows
-1
3,900 min
speed are desired.
-1
1,600 min
avoid screw thread breakage.
-1
3,900 min
control.
7 ENGLISH
Reversing switch action
Fig.7: 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
of rotation. Depress the reversing switch lever from the
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
driving screws with good control.
In this mode, the tool drives a screw with low-speed
trigger, the impact force can be changed.
Purpose Example of application
tightening bolts.
ening small screws such as M6.
-
-
-