Installation Of The First Display Unit In The System - Sony ZRD-1 Installation Manual

About the tool to be used for shaft lock
To lock or unlock a shaft, use the shaft lock bar.
You can also use a hexagon wrench (subtense : approx. 5 mm) for locking/unlocking a shaft.
In the procedure in this manual, the hexagon wrench is used.

2-4-3. Installation of the First Display Unit in the System

1. Place the display unit on the base.
. Place the display unit to the installation position by visual checking.
. Be sure to place the rear side first with the front side raised. If the front side is placed first, the edge
of the cell (LED module board) is hit against the installation surface, which may result in damage or
malfunction of cell.
Cell (LED module board)
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Edge of the cell (dotted line)
OK
Cell
NG
Cell
2-9 (E)