Data Backup Of Display Controller - Sony ZRD-1 Installation Manual

6-12. Data Backup of Display Controller

The setting data of the display controller is saved (backed up) as a profile in Display Control Software.
When the setting data is changed, the data is backed up automatically. The backup data is updated only for
the changed data.
The setting data of the display controller saved as a profile in Display Control Software is as follows.
Menu (Screen)
Controller Connection Settings
Unit Layout Settings
System Settings
Input Settings
Picture Settings
3D Settings (Except for S/N
2000001 to 2000100 of
ZRCT-100 SY model)
(*): These items are not displayed on Controller Connection Settings screen.
To back up the data manually
1. Display the Main screen.
2. On the menu bar, click [Tool], and then click [Back Up Controller Data].
The following dialog is displayed.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Items
Connection Type (LAN/SERIAL)
Primary (On/Off)
IP Address/COM Port
ID(*), Total(*)
Display Unit Allocation (display unit layout address of each display unit) (Example:
(1,2) and (C1-1-2))
Picture Allocation Number (picture starting point of each display unit) (Example: 7
(0,360))
Fan Mode
Photo Mode (Reserved)
Direct Array Power On
Light Output (Version earlier than 1.20.0)
Display Unit Power On Delay
Input Select
Output Start Position
High Frame Rate Mode
Single Stream Mode (Version 1.22.0 or later)
Dynamic Range (HDMI Signal Format (Version 1.20.0 or later)
Contrast, Brightness, Gamma, Color Space, Color Temperature Setting
Picture Mode, HDR, Light Output (Version 1.20.0 or later)
2D/3D (Version 1.22.0 or later)
3D Dual Input Mode (On/Off)
3D Dual Input 4K Mode (On/Off)
3D Sync Signal Invert Mode (On/Off)
3D Sync Signal Delay
6-35 (E)