Digital Readout - Grizzly G0605X Owner's Manual

4. loosen the jam nut (figure 73) on the 45°
stop bolt, adjust the stop bolt up or down,
then check to see if the blade is 45° to the
table.
Jam nut
figure 73. 45° stop bolt and jam nut.
5.
Continue adjusting the stop bolt until it con-
tacts the cabinet when the blade is at 45°.
6.
tighten the jam nut.
To adjust the tilt indicator arrow:
1.
set the 90° stop bolt (see instructions on
page 50).
2.
loosen the blade height handwheel set screw
and remove the handwheel.
3.
loosen the button head cap screw shown in
figure 74 and move the tip of the indicator to
0°.
indicator
figure 74. tilt indicator arrow.
4.
tighten the cap screw and reinstall the
handwheel.
model g0605X/g0606X (mfg. since 11/06)
45° stop Bolt
Button head
Cap screw

Digital Readout

the digital readout displays the current blade
angle. We recommend you set the readout after
verifying the 90° and 45° blade tilt stops.
To set the digital readout:
1. Ensure the 90° stop bolt is set (see Blade Tilt
Stops on page 50.
2. move the blade angle to 0° and press the 0°
sEt button (figure 75) for several seconds
until the readout displays 0.00.
0° set Button
figure 75. digital readout.
3. move the blade angle to 45° and press the
sEt button for several seconds until the
readout displays 45.0.
Note: If you move the blade angle handwheel
when the power is disconnected, the digital
readout will be incorrect when the saw is
reconnected.
45° set Button
-51-