Grizzly G0605X Owner's Manual page 54

Resaw Barrier
the resaw barrier shown in figure 54 holds the
workpiece vertical, keeps the workpiece aligned
with the fence, and keeps your hands away from
the blade.
figure 54. resawing barrier.
components Needed for the Resaw Barrier:
hardwood or plywood
3
hardwood or plywood
3
Wood screws / -20 x 2" ....................................8
1
4
Wood glue .........................................as needed
Tools Needed for the Resaw Barrier:
table saw ..........................................................1
Jointer and planer ....................... recommended
Clamps ............................................... 2 minimum
drill and drill Bits ................................................1
To build the resaw barrier:
1. Cut two boards to
x 3" x 40 ⁄ ". if you are using hardwood, cut
1
4
the boards oversize, then joint and plane the
boards to the correct size to make sure the
boards are square and flat.
Note: Only use furniture grade plywood or
kiln dried hardwood to prevent warping.
2. pre-drill and countersink 8 holes approxi-
mately ⁄ " from the bottom of the 7
3
8
board.
-40-
⁄ " x 7 ⁄ " x 40 ⁄ " ............1
1 1
4 2 4
⁄ " x 3" x 40 ⁄ " ...............1
1
4 4
⁄ " x 7 ⁄ " x 40 ⁄ " and
3 1 1 3
4 2 4
⁄ " tall
1
2
3.
glue the end of the 3" board, then clamp the
boards at a 90° angle with the larger board in
the vertical position as shown in figure 55.
figure 55. Clamping the resawing barrier.
4.
secure the joint with the wood screws.
Auxiliary fence
the auxiliary fence is necessary if you are
resawing a workpiece that is taller than it is wide.
it should be no less than
board to be resawn.
components Needed for the Auxiliary fence:
hardwood or plywood
Flat head screws m8-1.25 x 25 (not included) .4
hex nuts m8-1.25 (included) .............................4
Tools Needed for the Resaw Barrier:
table saw ..........................................................1
Jointer and planer ....................... recommended
⁄ "
Clamps ............................................... 2 minimum
4
drill and drill Bits ................................................1
To build the auxiliary fence:
1. Cut a ⁄ " thick board 40
3
4
height no less than
to be resawn. if you are using hardwood, cut
the board oversize, then joint and plane the
board to the correct size to make sure the
board is square and flat.
Note: Only use furniture grade plywood or
kiln dried hardwood to prevent warping.
2. pre-drill and countersink four holes 1
the bottom of the board.
model g0605X/g0606X (mfg. since 11/06)
⁄ " shorter than the
1
2
⁄ " x (height) x 40 ⁄ " ......1
3 1
4 4
⁄ " long, and cut a
1
4
⁄ " shorter than the board
1
2
⁄ " from
1
4